The G. LaMar Kirby Stove

Editor's note: Beyond the fact this is another very simple stove, I like very much the illustrations: including the  always mentioned coat hanger pot stand. This stove gave  birth to countless variations.

Home Made - Lightweight Backpack Stove Invented by: Unknown. Construction directions by: LaMar Kirby - Utah Lake District, Orem Ut. You can make this simple back backing stove with little cost ($0.25 US). This makes a great scout troop activity. What you'll need Parts List 2 Aluminum Soda Cans - Free 1/4 cup of Perlight (found in the gardening department) - $1.75 bag US Wire Coat Hanger - Free De-Natured alcohol (found in the paint dept. or boating supply) $3-4 Qt. Tools Scissors Drill 1/16" (2 mm) Drill Bit Wire Cutters Step 1 For the base, neatly cut one can about 1 1/2" (3.5cm) from the bottom. For the top, cut the other can about 1" (3.5cm) from the bottom. Step 2 Drill a number of holes (18-30) around the edge of the top and in the center as shown; use a 1/16" drill bit. Step 3 Fill the base with Perlight, just more than half full. Step 4 Make 6-8 vertical cuts around the top. Make the cuts up to the but not over the rounded edge. Slowly press the top into the bottom. (A small board can help make it even.) Step 5 Fill the stove about half full of alcohol. Light the burner by slowly moving a match or lighter over the edge of the burner. Note: If it does not stay lit, tip the burner up to leak some fuel into the rim and relight. Hold it until it stays lit or gets too hot. Step 6 Cut and straighten a coat hanger. Use a fine sandpaper to remove any paint or coatings. Bend the coat hanger wire (or any large gauge wire) into a shape that will hold a pot a few inches above the burner (see the example). Note: with a little imaginations you can create a number of stove bases That's It © Copyright G.LaMar Kirby, Utah 1996

The Author's Website: www.geocities.com/Yosemite/3482/

Previous Page   Home   Warning   Index   Links   Next Page